Pins 2 and 3 are symmetrically balanced and floating; Plug the other end of the cable to the appropriate load. Turning DRIVE clockwise will increase the input signal, and therefore increase the amount of applied gain reduction. Page 13 s Section 2 Operating Controls Readjust as needed to gate out noise -- external, as well as hiss from the unit.
|Published (Last):||2 December 2007|
|PDF File Size:||18.94 Mb|
|ePub File Size:||14.36 Mb|
|Price:||Free* [*Free Regsitration Required]|
And the output gain to 0 dB. HighPass - Try pressing this button in. If the sound is too thin set it back out. Bypass - This button should be in the out position. Compressor Start with the density set to about 6 Drive - Turn up until you reach the desired amount of gain reduction. Density - Adjust until the release of the gain reduction suits your taste. You really need to experiment with these settings to get the best results. If no De-Essing is required, turn it off. Enhancer LF Detail - Slowly turn up until the lows sound good, but not overbearing.
HF Detail - Turn up until the high end sounds clear, but not harsh. If you want to set the gate, start by setting the ratio to Threshold - While talking or singing in the mic, bring up the threshold until the signal will no longer open the gate. Now back it off until the gate will open when the signal is present. Ratio - Adjust this setting until the background noise once again becomes audible, then turn it back up slightly until the noise drops in level. Check the gate with the signal.
You may not be able to fully remove the noise, but you should be able to lower it. Output Gain - Adjust this until you have the desired amount of level feeding the next device. Views:
Salkree HighPass — Try pressing this button in. The five linear Dial adjustments include: Sign in to chat! Sign Up or Sign In. Five of these Dial adjustments are non-linear the scale is neither linear or logarithmic. Ratio — Adjust this setting until the background noise once again becomes audible, then turn it back up slightly until the noise drops in level. Check the gate with the signal. Compressor Start with the density set to about 6 Drive — Turn up until you reach the desired amount of gain reduction.
Dbx 286A Specification Sheet
dbx 286a richtig einstellen
dbx 286A Manuals & User Guides