High definition bit digital image signals offering 2. Table 1. Publication date: August Ver. In sensor master mode, make these terminals open. Totally 8 lines of ineffective data is output.
|Published (Last):||7 March 2006|
|PDF File Size:||15.64 Mb|
|ePub File Size:||7.38 Mb|
|Price:||Free* [*Free Regsitration Required]|
HD video p60 , 2. Full HD resolution at 12 bits and 60fps? Full scan resolution at 10 bits and fps? This marking can be seen on the top layer silkscreen of the printed circuit board, below the outside perimeter of the lens holder. Lens holder with adjustable focus? Selectable on-board Initial Setup and Handling The following is recommended reading prior to removing the evaluation board from the static shielding bag and may or may not apply to your particular use of the board.
Even so, the devices are static-sensitive to conditions that exceed their designed-in protection. As such, it is recommended that you wear an approved and functioning grounded wrist strap at all times while handling the evaluation boards when they are removed from the static shielding bag.
If you will not be using the boards for a while, it is best to put them back in the static shielding bag. Please save the static shielding bag and packing box for future storage of the boards when they are not in use. Likewise, when unplugging cables from the evaluation board, the last connection unplugged should be the chassis GND connection to the evaluation board GND.
If you have a signal source that is floating with respect to chassis GND, attempt to neutralize any static charge on that signal source prior to attaching it to the evaluation board. This will keep the board at the same voltage potential as your body until you can pick up the static shielding bag and put the board back in it.
Electrical, Mechanical, and Environmental Specifications The nominal board dimensions are 42mm x 42mm 1. Additional mechanical board dimension information is included on the mechanical drawing shown in Appendix A, Figure 7. On the physical board itself, connectors include pin 1 indictors as either an arrow, or triangle point near pin 1 on the outer layer silk screen. The environmental specifications are as follows:? The on-board linear voltage regulators then provide the necessary supply voltages to power the sensor: 3.
The regulator output voltages are set as shown in Table 1. Table 1. An external resistor divider network is used to divide down the regulator output and compare it against an internal reference voltage. The regulator adjusts the output voltage by comparing the feedback from the resistor divider network and the internal reference voltage.
By doing this, each regulator output voltage remains at a constant voltage value independent of the load it drives. Table 2. Table 3. February All Lattice trademarks, registered trademarks, patents, and disclaimers are as listed at www. All other brand or product names are trademarks or registered trademarks of their respective holders. The specifications and information herein are subject to change without notice.
Schematics Figure 3. Moore Court Hillsboro, Oregon.
MN34041 Sensor NanoVesta Headboard
Blackcam Hybrid BCH-950